Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Electronic Suspension Control Module Bracket Replacement
2018 Buick Regal BaseSECTION Electronic Suspension Control Module Bracket Replacement
WARNING: This page is about a different car, the 2020 Buick Regal TourX, 2020 Buick Regal, 2019 Buick Regal TourX, and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| Preliminary Procedure Electronic Suspension Control Module - Remove - Electronic Suspension Control Module Replacement |
|
| 1 | Electronic Suspension Control Module Bracket Nut [2x]
CAUTION:
Tighten 22 N.m (16 lb ft) |
| 2 | Electronic Suspension Control Module Bracket Bolt Tighten 22 N.m (16 lb ft) |
| 3 | Electronic Suspension Control Module Bracket |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.