Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Wheel Speed Sensor(1) - Install
- CAUTION:
Wheel Speed Sensor Bolt(1) - Install and tighten9 N.m (80 lb in)
Retainer(1)@Steering Knuckle - Secure
Retainer(1)@Front Brake Hose - Secure[2x]
Retainer(1)@Side Rail - Secure[3x]
Retainer(1)@Radiator Support - Secure
- Wheel Speed Sensor Electrical Connector - Connect
- Front Wheelhouse Liner - Install - Front Wheelhouse Liner Replacement (3.6L LGX) or Front Wheelhouse Liner Replacement (2.0L LTG)
- Verify the repair is complete. Refer to Diagnostic Repair Verification
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.