2018 Buick Envision BaseFACTORY OEM SERVICE PROCEDURE

K188 Human Machine Interface Control Module Bypass Module X1

GM4231339Courtesy of GENERAL MOTORS COMPANY
Connector Part Information
  • Harness Type: Instrument Panel
  • OEM Connector: 13596105
  • Service Connector: 13596105
  • Description: 20-Way F Mini 50 Series (BK)
Terminal Part Information

Terminal Type ID Terminated Lead Diagnostic Test Probe Terminal Removal Tool Service Terminal Tray Name Core Crimp Insulation Crimp
I Not Required No Tool Required No Tool Required Not Available Not Available Not Available Not Available
Pin Size Color Circuit Function Terminal Type ID Option
1 0.35 RD/YE 5040 Battery Positive Voltage I -
2 0.35 VT 801 Retained Accessory Power Fuse Control I -
3 0.35 GN/WH 7527 Local Interconnect Network Serial Data Bus 5 I -
4 - - - Not Occupied - -
5 0.35 BK 1750 Ground I -
6 0.35 GY/YE 6972 Camera Signal 2 + I -
7 0.35 BARE 6974 Camera Low Reference I -
8 0.35 GY/YE 6972 Camera Signal 2 + I -
9 0.35 GN/WH 1324 Backup Lamp Control I -
10 - 17 - - - Not Occupied - -
18 0.35 WH/BU 6973 Camera Signal 2 I -
19 0.35 BARE 6974 Camera Low Reference I -
20 0.35 WH/BU 6973 Camera Signal 2 I -
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.