Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Buick Verano Base, GasFACTORY OEM SERVICE PROCEDURE
Fastener Specifications
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Intermediate Steering Shaft Bolt | 34 N.m (25 lb ft) |
| Power Steering Assist Motor Bolt | 8 N.m (71 lb in) |
| Stabilizer Shaft Link Nut | 65 N.m (48 lb ft) |
| Steering Gear Bolt | |
|
110 N.m (81 lb ft) |
|
150 - 160 degrees |
| Steering Linkage Outer Tie Rod Nut | 35 N.m (26 lb ft) |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Power Steering Fluid Cooling Pipe Bracket Nut | 9 N.m (80 lb in) |
| Power Steering Fluid Reservoir Screw | 9 N.m (80 lb in) |
| Power Steering Gear Inlet and Outlet Hose Bolt | 11 N.m (97 lb in) |
| Power Steering Pump Bolt | 22 N.m (16 lb ft) |
| Power Steering Pump Hollow Screw | 45 N.m (33 lb ft) |
| Steering Gear Valve Solenoid Bolt | 8 N.m (71 lb in) |
| Steering Linkage Inner Tie Rod (Electronic Power Steering) | 105 N.m (77 lb ft) |
| Steering Linkage Inner Tie Rod (Hydraulic Power Steering) | 90 N.m (66 lb ft) |
| Steering Linkage Inner Tie Rod Nut | 60 N.m (44 lb ft) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.