Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Buick Verano Base, GasFACTORY OEM SERVICE PROCEDURE
Installation Procedure
- Clip the 2 chassis control module clips (4) to the chassis control module bracket (3).
- Clip the chassis control module bracket clip (2) to the chassis control module (1).
- Plug the chassis control module wiring harness plug (2) to the chassis control module (1).
- Install the rear compartment side trim - right side. Refer to Rear Compartment Side Trim Replacement - Right Side .
- If replacing the module, reprogram the module. Refer to Control Module References .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.