2017 Buick LaCrosse BaseFACTORY OEM SERVICE PROCEDURE

Active Safety Control Module Replacement

Fig 1: Active Safety Control Module
GM4289939Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Rear Compartment Side Trim Replacement - Left Side (With LHN)Rear Compartment Side Trim Replacement - Left Side (With LGX) - Reposition
1 Active Safety Control Module Bracket Bolt
Procedure 
Loosen the active safety control module bracket retaining bolts and reposition from the interior body panel.
Tighten 
2.5 N.m (22 lb in)
2 Active Safety Control Module

Procedure

  1. Release the locking retainer from the active safety control module bracket.
  2. Disconnect the electrical connectors.
  3. Perform the necessary programming and setup procedure:Control Module References
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.