Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Programming an Existing or New Control Module
This control module does not require SPS programming or any setup procedures.
This control module does not require SPS programming but does require the following setup procedures after a new control module is installed:
To program an existing or new control module, perform the following procedure:
- Install the special tool: EL-49642 SPS Programming Support Tool
- Ignition - On/Vehicle - In Service Mode
- Access SPS and follow the on-screen instructions for the control module: Q8 Control Solenoid Valve Assembly or K71 Transmission Control Module
- Perform the following learn procedure: Transmission Adaptive Values Learn
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.