Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Buick Envision BaseFACTORY OEM SERVICE PROCEDURE
Fastener Specifications
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal.Β |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Battery Fuse Block @ Battery Positive Post Fastener | 4.5 N.m (40 lb in) |
| Battery Negative Cable @ Battery Sensor Stud Fastener | 12 N.m (106 lb in) |
| Battery Negative Cable Clamp @ Negative Battery Post Fastener | 4.5 N.m (40 lb in) |
| Battery Negative Cable Ground Terminal @ Engine Block Fastener (LCV, LTG) | 40 N.m (30 lb ft) |
| Battery Negative Cable Ground @ Radiator Support Fastener | 22 N.m (16 lb ft) |
| Battery Negative Cable Ground Terminal @ Upper Tie Bar Support Stud Fastener (LCV, LTG) | 22 N.m (16 lb ft) |
| Battery Positive Cable @ Battery Fuse Block Fastener | 12 N.m (106 lb in) |
| Battery Positive Cable @ Generator Fastener (LCV, LTG) | 15 N.m (11 lb ft) |
| Battery Positive Cable @ Starter Solenoid Fastener (LCV, LTG) | 12 N.m (106 lb in) |
| Battery Positive Junction Block Cable Fastener | 12 N.m (106 lb in) |
| Battery Retaining Bracket Fastener | 9 N.m (80 lb in) |
| Battery Tray Fastener | 22 N.m (16 lb in) |
| Engine Wiring Harness Junction Block Cable Fastener | 12 N.m (106 lb in) |
| Fuse Block Bolt (Engine Wiring Harness Junction Block) | 7 N.m (62 lb in) |
| Generator Mounting Bolt (LCV, LTG) | 22 N.m (16 lb in) |
| Generator Mounting Nut (LCV, LTG) | 22 N.m (16 lb in) |
| Generator Mounting Stud (LCV, LTG) | 9 N.m (80 lb in) |
| Starter Mounting Bolt (LCV, LTG) | 22 N.m (16 lb in) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
