Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Buick Envision BaseFACTORY OEM SERVICE PROCEDURE
Diagnostic Aids
- If any one of the cameras is replaced on the Surround Vision Camera System, the displayed image may not be correctly stitched due to a change in the location or orientation of the camera. The only way to correct an incorrectly stitched image is to perform the calibration procedure.
- Tires must be inflated properly
- Vehicle must be on a level surface
- Mirrors must be folded out
- It is a good practice to wipe camera lens' clean prior to alignment
- Interfering objects or glare from overhead lighting will fail an alignment
- All points of access to the inside of the vehicle Must be closed, including hood.
- Finalize is the very last step, this saves all the data from the alignment
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.