Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Buick Encore BaseFACTORY OEM SERVICE PROCEDURE
Fastener Specifications
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Battery Hold Down Retainer Fastener | 22 N.m (16 lb ft) |
| Battery Negative Cable Post Fastener | 4.5 N.m (40 lb in) |
| Battery Negative Cable to Battery Sensor (KL9) | 11 N.m (97 lb in) |
| Battery Negative Cable to Engine Block (LVL) | 22 N.m (16 lb ft) |
| Battery Negative Cable to Frame Rail Stud Fastener | 22 N.m (16 lb ft) |
| Battery Negative Cable to Starter Mounting Stud (LDE) | 17 N.m (13 lb ft) |
| Battery Positive Cable Fastener to Starter Solenoid Fastener | 13 N.m (115 lb in) |
| Battery Positive Cable Post Fastener | 5 N.m (44 lb in) |
| Battery Positive Cable to Battery Fuse Block Fastener | 12 N.m (106 lb in) |
| Battery Positive Cable to Underhood Fuse Box Fastener | 9 N.m (80 lb in) |
| Battery Tray Fastener | 14 N.m (124 lb in) |
| Body Harness Ground to Battery Negative Clamp | 9 N.m (80 lb in) |
| Engine Harness Starter Positive Cable | 5 N.m (44 lb in) |
| Generator Battery Positive Cable Fastener | 17 N.m (13 lb ft) |
| Generator Mounting Fastener (2HO, LUJ) | 35 N.m (26 lb ft) |
| Generator Mounting Fastener (LE2, LVL) | 22 N.m (16 lb ft) |
| Generator Mounting Stud (LE2) | 9 N.m (80 lb in) |
| Heated Oxygen Sensor Bracket Fastener | 25 N.m (18 lb ft) |
| Starter Battery Negative Cable Ground Fastener | 17 N.m (13 lb ft) |
| Starter Battery Positive Cable Fastener | 13 N.m (115 lb in) |
| Starter Mounting Fastener (LE2) | 58 N.m (43 lb ft) |
| Starter Mounting Fastener (LVL) | 22 N.m (16 lb ft) |
| Starter Mounting Stud | 25 N.m (18 lb ft) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.