Single Use Threaded Fastener/Component Tightening Specifications

NOTE: All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.
Application	Specification
Application	Metric (English)
Stabilizer Shaft Insulator Clamp Bolt
First Pass:	22 N.m (16 lb ft)
Final Pass:	30 degrees
Steering Gear Nut
First Pass:	110 N.m (81 lb ft)
Final Pass:	150-165 degrees
Steering Linkage Tie Rod Nut
First Pass:	35 N.m (26 lb ft)
Final Pass:	30-45 degrees

Reusable Threaded Fastener Tightening Specifications

NOTE: All fasteners listed in this table can be reused after removal.
Application	Specification
Application	Metric (English)
Front Suspension Frame Rear Bolt	160 N.m (118 lb ft)
Power Steering Assist Motor Bolt	8 N.m (71 lb in)
Stabilizer Shaft Link Nut	65 N.m (48 lb ft)
Steering Gear Heat Shield Bolt	9 N.m (80 lb in)
Steering Linkage Inner Tie Rod Nut	60 N.m (44 lb ft)
Steering Linkage Inner Tie Rod to Steering Gear	105 N.m (77 lb ft)
Transmission Mount Bracket Bolt	100 N.m (74 lb ft)
Transmission Mount Bolt	100 N.m (74 lb ft)
Wiring Harness Bracket Bolt	9 N.m (80 lb in)

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Fastener Specifications