Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Buick EnvisionFACTORY OEM SERVICE PROCEDURE
Fastener Specifications
WARNING: This page is about a different car, the 2016 Buick LaCrosse. However, it is still accessible from the selected car via links, so may be relevant.
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Front Suspension Frame Rear Bolt | 160 N.m | 118 lb ft |
| Front Suspension Frame Reinforcement Bolt | ||
|
60 N.m | 44 lb ft |
|
30 Degrees | |
| Power Steering Assist Motor Bolt (NJ1) (Requires a NEW bolt.)Β | 8 N.m | 71 lb in |
| Power Steering Assist Motor Pivot Bolt (NJ2) (Requires a NEW bolt.)Β | 22 N.m | 16 lb ft |
| Power Steering Fluid Reservoir Bracket Bolt | 9 N.m | 80 lb in |
| Power Steering Fluid Reservoir Inlet Hose Fitting (at Power Steering Fluid Cooler) | 38 N.m | 28 lb ft |
| Power Steering Gear Inlet and Outlet Hose Bolt | 9 N.m | 80 lb in |
| Power Steering Gear Inlet Hose Bolt | 50 N.m | 37 lb ft |
| Power Steering Gear Outlet Hose Fitting (at Power Steering Fluid Cooler) | 38 N.m | 28 lb ft |
| Power Steering Pump Bolt | 22 N.m | 16 lb ft |
| Steering Gear Bolt (Requires a NEW bolt.)Β | ||
|
110 N.m | 81 lb ft |
|
150 Degrees | |
| Steering Gear Heat Shield Bolt | 9 N.m | 80 lb in |
| Steering Gear Housing Cover Bolt (M6, NJ2) (Requires a NEW bolt.)Β | 10 N.m | 89 lb in |
| Steering Gear Housing Cover Bolt (M8, NJ2) (Requires a NEW bolt.)Β | 22 N.m | 16 lb ft |
| Steering Gear Pipe Fitting | 19 N.m | 14 lb ft |
| Steering Gear Pipe Retainer Bolt | 12 N.m | 106 lb in |
| Steering Gear Wiring Harness Bracket Bolt | 9 N.m | 80 lb in |
| Steering Linkage Inner Tie Rod | 100 N.m | 74 lb ft |
| Steering Linkage Inner Tie Rod Nut | 60 N.m | 44 lb ft |
| Steering Linkage Outer Tie Rod Nut | ||
|
35 N.m | 26 lb ft |
|
30 Degrees | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
