2016 Buick EnvisionFACTORY OEM SERVICE PROCEDURE

Distance Sensing Cruise Control Module Scan Tool Information

WARNING: This page is about a different car, the 2015 Buick LaCrosse. However, it is still accessible from the selected car via links, so may be relevant.
Cruise Control Vehicle Distance Sensor Module Scan Tool Data Parameters

Parameter System State Expected Value Description
Operating Conditions:Β  Engine Running/Cruise Control ON
Automatic Alignment Learn Progress - Varies The scan tool displays a percent complete value. This is the current status of the alignment progress.
Automatic Alignment Learn Status - Learn Successful The scan tool displays Off, Ready, Learn Failed. Learn Successful or Busy. This is the learn state of the automatic alignment.
Brake Pedal Position Sensor - Varies The scan tool displays Released or Applied depending on the state of the brake pedal
Cruise Control Disengage History 1-4 - Varies This is the state of the ACC disable history.
Cruise Control Driver Memory - - Driver 1 or Driver 2
Cruise Control Inhibit Data - - This is the cruise control inhibit reason.
Cruise Control On/Off Switch Status - On The scan tool displays On or Off. This is the state of the cruise on/off switch.
Cruise Control Throttle Override By Driver - Varies The scan tool displays Active or Inactive. This is the state of the throttle override.
Cruise Control Throttle Override By Driver Indicator Message - - Active/Inactive
Distance Sensing Cruise Control Status - - Active/Inactive
Distance Sensing Cruise Control Type - - Full Speed Range or Limited Speed Range
Following Distance Setting - Varies The scan tool displays Stage 1, Stage 2 or Stage 3. This is the selected following distance.
Horizontal Alignment Angle - - The scan tool displays a percentage value.
Ignition Voltage Signal - 11-14 V The scan tool displays a voltage value. This is the current ignition voltage signal.
Radar Needs Cleaning - No The scan tool displays Yes or No.
Radar Temporarily Unavailable Indicator Message - - Active/Inactive
Service Radar Display Message - Inactive The scan tool displays Active or Inactive. Active will be displayed when the cruise control vehicle distance sensor module detects a malfunction in the ACC system.
System Voltage - 11-14 V The scan tool displays a voltage value. This is the current battery voltage.
Vertical Alignment Angle - - The scan tool displays a percentage
Cruise Control Vehicle Distance Sensor Module Scan Tool Output Controls

Output Control Description
Distance Sensing Cruise Control Service Alignment The cruise control vehicle distance sensor module will activate the alignment/calibration procedure when selected.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.