Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
If Slow to Calibrate
2016 Buick Encore Base, AWDSECTION If Slow to Calibrate
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
One or more of the following conditions may increase the length of time required to complete the self-calibration procedure:
- Heavy traffic
- Stop and go traffic
- Mountain roads
- Curves in roadway
- Poor contrast lane markings
- Botts' Dots type lane markings
- Operating the vehicle speed is greater than 90 km/h (56 MPH)
- Driving through snow or fog, or driving directly into the sun
- Camera not properly installed. Verify it is snapped into tabs and is secure. Refer to Front View Camera Replacement (Encore) .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.