SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2016ENCORE BASE, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 39 (DISC BRAKE SYSTEM)SPECIFICATIONSDISC BRAKE COMPONENT SPECIFICATIONS
2016 Buick Encore Base, AWD

Disc Brake Component Specifications

2016 Buick Encore Base, AWDSECTION Disc Brake Component Specifications
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
Application Specification
Metric English
Front Rotor
  • Rotor Diameter
 300.0 mm 11.810 in
  • Rotor Discard Thickness*
 23.0 mm 0.905 in
  • Rotor Maximum Allowable Assembled Lateral Runout
 0.06 mm 0.002 in
  • Rotor Maximum Allowable Scoring
 1.50 mm 0.059 in
  • Rotor Maximum Allowable Thickness Variation
 0.025 mm 0.001 in
  • Rotor Minimum Allowable Thickness After Refinish
 23.2 mm 0.913 in
  • Rotor Thickness New
 26.0 mm 1.023 in
Rear Rotor
  • Rotor Diameter
 268.0 mm 10.551 in
  • Rotor Discard Thickness*
 10 mm 0.393 in
  • Rotor Maximum Allowable Assembled Lateral Runout
 0.05 mm 0.002 in
  • Rotor Maximum Allowable Thickness Variation
 0.025 mm 0.001 in
  • Rotor Maximum Allowable Scoring
 1.50 mm 0.059 in
  • Rotor Minimum Allowable Thickness After Refinish
 10.2 mm 0.402 in
  • Rotor Thickness New
 12.0 mm 0.472 in
* All brake rotors have a minimum thickness dimension cast into them. Replace any rotor that is worn or machined below this specification.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.