Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Front View Camera Module Reprogramming
2016 Buick Encore Base, AWDSECTION Front View Camera Module Reprogramming
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
Do not reprogram the Front View Camera Module, unless directed by a service procedure, or a service bulletin.
- Connect a scan tool to the vehicle and access Service Programming System (SPS).
- Perform the SPS function Front View Camera Module - Programming and follow the on-screen instructions.
- Clear DTCs after completing the programming procedure.
- Following programming, the module will require calibration. Refer to Front View Camera Module Calibration .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.