Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2016ENCORE BASE, AWDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSKEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONS
2016 Buick Encore Base, AWD
Keyless Entry System And Remote Functions
2016 Buick Encore Base, AWDSECTION Keyless Entry System And Remote Functions
- Schematic Wiring Diagrams
- Diagnostic Information and Procedures
- DTC B3101: Keyless Entry Data Link
- DTC B3105: Keyless Entry Transmitters
- DTC B3106: Keyless Entry Data Link
- DTC B3109-B3113: Keyless Entry Transmitter 1-5 Battery
- DTC B310D-B310F: Keyless Entry Transmitter 6-8 Battery
- Symptoms - Remote Functions
- Keyless Entry System Malfunction
- Remote Vehicle Start Malfunction
- Repair Instructions
- Description and Operation
- Keyless Entry System Description and Operation
- Notes
- Keyless Entry Transmitters
- OnStar® Remote Link (if equipped)
- Body Control Module (BCM)
- Remote Control Door Lock Receiver
- Unlock Doors
- Lock All Doors
- Trunk Release, if equipped
- Power Liftgate, if equipped
- Vehicle Locator/Panic Alarm
- Remote Vehicle Start, if equipped
- Enable/Disable Remote Vehicle Start
- Hood Ajar Switch
- Remote Vehicle Start Circuit Description
- Keyless Entry Personalization
- Keyless Entry System Description and Operation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.