Communication Interface Module Bracket Replacement (Trax)

2016 Buick Encore Base, AWDSECTION Communication Interface Module Bracket Replacement (Trax)
Fig 1: Communication Interface Module Bracket (Trax)
GM2870836Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Remove the instrument panel compartment. Refer to Instrument Panel Compartment Replacement .
  2. Remove the instrument panel lower trim panel insulator. Refer to Instrument Panel Lower Trim Panel Insulator Replacement .
  3. Remove the floor auxiliary mat lower retainer, if equipped. Refer to Floor Auxiliary Mat Lower Retainer Replacement (Trax) .
  4. Remove the instrument panel lower airbag passenger side, if equipped. Refer to Instrument Panel Lower Airbag Replacement - Passenger Side (AYF) .
1 Communication Interface Module Bracket Bolts (Qty: 2)
CAUTION:

Refer to Fastener Caution .

2 Communication Interface Module Bracket

Procedure

  1. Disconnect the electrical connectors.
  2. Transfer components as necessary.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.