SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2016ENCORE BASE, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE CONTROLS AND FUEL - 1.4L (LUV) - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSAIR CLEANER ASSEMBLY REPLACEMENT
2016 Buick Encore Base, AWD

Air Cleaner Assembly Replacement

2016 Buick Encore Base, AWDSECTION Air Cleaner Assembly Replacement
Fig 1: Air Cleaner Assembly
GM2777386Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Disconnect the mass airflow sensor electrical connector.
  2. Remove the air cleaner inlet duct. Refer to Air Cleaner Inlet Duct Replacement .
  3. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
1 Air Cleaner Assembly
Procedure 
Remove the air cleaner assembly by pulling upward to release the assembly from the lower rubber grommets and then pulling outward from the fender.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.