Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2016ENCORE BASE, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLANTILOCK BRAKE SYSTEMREPAIR INSTRUCTIONSVEHICLE STABILITY CONTROL SYSTEM SWITCH REPLACEMENT
2016 Buick Encore Base, AWD
Vehicle Stability Control System Switch Replacement
2016 Buick Encore Base, AWDSECTION Vehicle Stability Control System Switch Replacement
| Callout | Component Name |
|---|---|
| Preliminary Procedure Remove the heater and air conditioning control. Refer to Heater and Air Conditioning Control Replacement . |
|
| 1 | Vehicle Stability Control System Switch Fastener (Qty: 2)
CAUTION:
Refer to Fastener Caution . Tighten 1.2 N.m (11 lb in) |
| 2 | Vehicle Stability Control System Switch |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.