2016 Buick Cascada BaseFACTORY OEM SERVICE PROCEDURE

Fastener Specifications

Application Specification
Metric English
Front Suspension Frame Rear Bolt 160 N.m 118 lb ft
Power Steering Assist Motor Bolt 8 N.m 71 lb in
Stabilizer Shaft Insulator Clamp Bolt (1)
  • First Pass
 22 N.m 16 lb ft
  • Final Pass
 30 degrees
Stabilizer Shaft Link Nut 65 N.m 48 lb ft
Steering Gear Heat Shield Bolt 9 N.m 80 lb in
Steering Gear Nut (1)
  • First Pass
 110 N.m 81 lb ft
  • Final Pass
 150 - 165 degrees
Steering Linkage Inner Tie Rod to Steering Gear 105 N.m 77 lb ft
Steering Linkage Inner Tie Rod Nut 60 N.m 44 lb ft
Steering Linkage Tie Rod Nut (1)
  • First Pass
 35 N.m 26 lb ft
  • Final Pass
 30 to 45 degrees
Transmission Mount Bracket Bolt 100 N.m 74 lb ft
Transmission Mount Bolt 100 N.m 74 lb ft
Wiring Harness Bracket Bolt 9 N.m 80 lb in
(1) = Use NEW Fastener.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.