Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Buick Cascada BaseFACTORY OEM SERVICE PROCEDURE
Section 81 (Object Detection System)
WARNING: This page is about a different car, the 2016 Chevrolet Malibu Limited. However, it is still accessible from the selected car via links, so may be relevant.
- Schematic Wiring Diagrams
- Diagnostic Information and Procedures
- DTC B094C: Right Side Object Detection Control Module
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Diagnostic Aids
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC B0958, B0959, B0960 or B0961: Parking Assist Rear Sensor Left/Right Corner/Middle Circuit
- Diagnostic Instructions
- DTC Descriptors
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC B0967 or B0968: Parking Assist On/Off Switch
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC B0987: Vehicle Direction Camera Indicator Circuit
- DTC B1011: System Disabled Information Stored Malfunction
- DTC B1015: Vehicle Identification Number Information Malfunction
- DTC B101D: Electronic Control Unit Hardware (With Side Blind Zone Alert, UFT)
- DTC B101D: Electronic Control Unit Hardware (DTC Set in K109 Frontview Camera Module)
- DTC B1405: Control Module Voltage Reference Output 2 Circuit
- DTC B356A: Vehicle Direction Warning Switch Circuit
- Diagnostic Instructions
- DTC Descriptors
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Diagnostic Aids
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- Symptoms - Object Detection
- Forward Collision Alert System Malfunction
- Parking Assist System Malfunction
- Rear Vision Camera System Malfunction
- Side Object System Malfunction
- Lane Departure Warning System Malfunction
- DTC B094C: Right Side Object Detection Control Module
- Repair Instructions
- Description and Operation
- Object Detection Description and Operation (Lane Departure Warning, UFL)
- Object Detection Description and Operation (Forward Collision Alert, UEU)
- Object Detection Description and Operation (Rear Vision Camera, UVC)
- Object Detection Description and Operation (Park Assist, UD7)
- Object Detection Description and Operation (Side Blind Zone Alert, UFT)
- Parking Assist Description and Operation
- Lane Departure Warning Description and Operation
- Side Blind Zone Alert Description and Operation
- Forward Collision Alert Description and Operation
- Rear Vision Camera Description and Operation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.
