WARNING: This page is about a different car, the 2016 Chevrolet Malibu Limited. However, it is still accessible from the selected car via links, so may be relevant.

If programming a control module is not successful, perform the following procedure:

Verify the control module, data link connector and programming tool connections are secure and the SPS software is up to date.
Ignition» On / Vehicle» In Service Mode
Perform one of the following SPS Programming functions:
NOTE: If both controller options below are listed, select K20/K71 Engine and Transmission Control Modules.
- K20/K71 Engine and Transmission Control Modules and follow the on-screen instructions.
- K20 Engine Control Module and follow on-screen instructions.
Verify the control module programming is successful.
- If the programming is not successful
1. Ignition/Vehicle » Off - For greater than 1 min
2. Ignition » On / Vehicle » In Service Mode
3. Perform one of the following SPS Programming functions:
  NOTE: If both controller options below are listed, select K20/K71 Engine and Transmission Control Modules.
  - K20/K71 Engine and Transmission Control Modules and follow the on-screen instructions.
  - K20 Engine Control Module and follow on-screen instructions.
  - If the programming is not successful. Replace the appropriate component: K20 Engine Control Module orK71 Transmission Control Module
  - If the programming is successful
4. All OK.
- If the programming is successful
All OK.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Unsuccessful Programming Recovery

Use the Manual With the Right Hardware

When to See a Mechanic