Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Buick Cascada BaseFACTORY OEM SERVICE PROCEDURE
Spark Plug Replacement
| Callout | Component Name |
|---|---|
| Preliminary Procedure Remove the ignition coil. Refer to Ignition Coil Replacement . |
|
| 1 | Spark Plug
CAUTION:
Refer to Fastener Caution . Tighten 17 N.m (13 lb ft) Special Tools EN-51149 Spark Plug Remover / Installer For equivalent regional tools, refer to Special Tools (Diagnostic Tools)Special Tools (Removal and Installation) . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.