Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2015ENCLAVE CONVENIENCEREPAIR AND DIAGNOSISGENERAL INFORMATIONRESET PROCEDURESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSFRONT AND REAR PARKING ASSIST CONTROL MODULE PROGRAMMING AND SETUPREPROGRAM FRONT AND REAR PARKING ASSIST CONTROL MODULE
2015 Buick Enclave Convenience
Reprogram Front and Rear Parking Assist Control Module
2015 Buick Enclave ConvenienceSECTION Reprogram Front and Rear Parking Assist Control Module
Do not reprogram the K41 Front and Rear Parking Assist Control Module, unless directed by a service procedure, or a service bulletin.
- Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS)
- Perform the SPS function K41 Front and Rear Parking Assist Control Module Programming and follow the on-screen instructions.
- Clear DTCs after completing the programming procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.