Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Buick Verano BaseFACTORY OEM SERVICE PROCEDURE
Installation Procedure
- Install the windshield into the opening with an assistant. Refer to Adhesive Installation of Stationary Windows (Body Side Front Window) , Adhesive Installation of Stationary Windows (Rear Window) , Adhesive Installation of Stationary Windows (Windshield) , Adhesive Installation of Stationary Windows (Quarter Window) .
- Install the windshield side reveal molding. Refer to Windshield Side Reveal Molding Replacement .
- Install the inside rearview mirror. Refer to Inside Rearview Mirror Replacement .
- Install the windshield garnish molding. Refer to Windshield Garnish Molding Replacement .
- Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
- Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
- Connect the battery. Refer to Battery Negative Cable Disconnection and Connection .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
