SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2014ENCLAVE CONVENIENCEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 102 (OBJECT DETECTION AND PEDESTRIAN PROTECTION SYSTEM)REPAIR INSTRUCTIONSPARKING ASSIST CONTROL MODULE REPLACEMENT
2014 Buick Enclave Convenience

Parking Assist Control Module Replacement

2014 Buick Enclave ConvenienceSECTION Parking Assist Control Module Replacement
WARNING: This page is about a different car, the 2015 GMC Acadia, 2015 Chevrolet Traverse, and 2015 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Object Alarm Module
GM1847695Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Remove the left rear quarter lower trim panel. Refer to Quarter Lower Rear Trim Panel Replacement (Traverse with TB5)Quarter Lower Rear Trim Panel Replacement (Traverse with TB4)Quarter Lower Rear Trim Panel Replacement (Enclave with TB5)Quarter Lower Rear Trim Panel Replacement (Enclave with TB4)Quarter Lower Rear Trim Panel Replacement (Acadia with TB5)Quarter Lower Rear Trim Panel Replacement (Acadia with TB4) .
  2. Remove the liftgate actuator (if equipped). Refer to Liftgate Actuator Replacement .
1 Communication Interface Module Bracket

Procedure

  1. Disconnect the body harness from the bracket as required.
  2. Loosen the bracket fasteners to remove the bracket from the slotted holes.
  3. Disconnect the electrical connectors.
2 Rear Object Alarm Module
Procedure 
Refer to Control Module References Control Module References for programming and set up.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.