Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSBUICK2014ENCLAVE CONVENIENCEREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTILOCK BRAKE SYSTEMREPAIR INSTRUCTIONSELECTRONIC BRAKE CONTROL MODULE REPLACEMENT

2014 Buick Enclave Convenience

Electronic Brake Control Module Replacement

2014 Buick Enclave ConvenienceSECTION Electronic Brake Control Module Replacement

Fig 1: Identifying Electronic Brake Control Module

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
CAUTION: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM. Preliminary Procedures Turn the ignition switch to the OFF position. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement . Clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area of any accumulated dirt and foreign material.
1	Electronic Brake Control Module (EBCM) Electrical Connector Procedure Lift the EBCM electrical connector locking lever upward.
2	EBCM Bolt (Qty: 4) CAUTION: Refer to Fastener Caution . Tighten 3 N.m (27 lb in)
3	EBCM Procedure Separate the EBCM from the brake pressure modulator valve (BPMV) by carefully pulling apart. Do not pry apart. Clean the sealing surface of the BPMV with denatured alcohol and a clean shop cloth. If installing a new EBCM, program the EBCM. Refer to Control Module References .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.