Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Buick Verano BaseFACTORY OEM SERVICE PROCEDURE
Fastener Tightening Specifications
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Intermediate Steering Shaft Bolt | 34 | 25 lb ft |
| Power Steering Assist Motor Bolt | 8 (1) | 71 lb in (1) |
| Stabilizer Shaft Link Nut (1) | 65 | 48 lb ft |
| Steering Gear Bolt | 110 + 150 degrees to 165 degrees (1) | 81 lb ft + 150 degrees to 165 degrees (1) |
| Steering Gear Valve Solenoid Bolt | 8 | 71 lb in |
| Steering Linkage Inner Tie Rod | 105 | 77 lb ft |
| Steering Linkage Inner Tie Rod Nut | 60 | 44 lb ft |
| Steering Linkage Outer Tie Rod Nut | 35 (1) | 26 lb ft (1) |
| Steering Wheel Bolt | 30 | 23 lb ft |
| 1 = Use NEW Fastener. | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
