Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013LACROSSE FWD L4-2.4LREPAIR AND DIAGNOSISBODY AND FRAMEFRAMESUBFRAMEFRONT SUBFRAME MOUNTSERVICE AND REPAIR
2013 Buick LaCrosse FWD L4-2.4L
Front Subframe Mount: Service and Repair
2013 Buick LaCrosse FWD L4-2.4LSECTION Service and Repair
Drivetrain and Front Suspension Frame Insulator Replacement
Special Tools
CH-49384 Remover/Installer
For equivalent regional tools, refer to Special Tools .
Removal Procedure
1.Separate the frame from the body approximately 70 mm. Refer to Drivetrain and Front Suspension Frame Replacement Service and Repair .
2.Remove the bushings using a
CH-49384 remover/installer (2).
Installation Procedure
1.Locate the front bushings as shown.
2.Install the bushings using
CH-49384 remover/installer.
3.Install the frame to the body. Refer to Drivetrain and Front Suspension Frame Replacement Service and Repair .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.