Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Buick VeranoFACTORY OEM SERVICE PROCEDURE
Assemble Procedure
- Install the fuel tank baffles. Refer to Fuel Tank Baffle Replacement .
- Install the evaporative emission canister (1) to the evaporative emission canister bracket (3).
- Connect the evaporative emission canister purge pipe (4).
- Remove the CH-807 plug from the fuel tank vent pipe.
- Connect the fuel tank vent pipe (2).
- Install the fuel tank fuel pump module. Refer to Fuel Tank Fuel Pump Module Replacement .
- Install the fuel tank heat shield. Refer to Fuel Tank Heat Shield Replacement .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.