Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Buick VeranoFACTORY OEM SERVICE PROCEDURE
Theft Deterrent Module Replacement
Theft Deterrent Module Replacement
| Callout | Component Name |
|---|---|
| Preliminary Procedures Remove the steering column lower trim cover. Refer to Steering Column Lower Trim Cover Replacement . |
|
| 1 | Theft Deterrent Module Fastener (Qty: 2)
CAUTION:
Refer to Fastener Caution |
| 2 | Theft Deterrent Module Procedure Disconnect the electrical connector. After repairs, refer to Control Module References for programming and set up information. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.