Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Buick Regal GS, Automatic TransFACTORY OEM SERVICE PROCEDURE
Direct Fuel Injector Replacement
Direct Fuel Injector Replacement
| Callout | Component Name |
|---|---|
| Preliminary Procedure Remove the fuel injection fuel rail assembly. Refer to Fuel Injection Fuel Rail Assembly Replacement . |
|
| 1 | Direct Fuel Injector Procedure Disconnect the electrical connector. |
| 2 | Direct Fuel Injector Procedure Remove the injector with EN-37281-A injector remover and DT-2619-01 slide hammer. Special Tools
For equivalent regional tools, refer to Special Tools (Diagnostic Tools) . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.