Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Buick Regal BaseFACTORY OEM SERVICE PROCEDURE
Fastener Tightening Specifications
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Power Steering Assist Motor Bolt | 8 N.m | 71 lb in |
| Power Steering Fluid Reservoir Bolt | 4 N.m | 35 lb in |
| Power Steering Gear Heat Shield Fastener | 9 N.m | 80 lb in |
| Power Steering Gear Inlet Hose Fitting Bolt | 38 N.m | 28 lb ft |
| Power Steering Gear Inlet and Outlet Hose Fastener | 9 N.m | 80 lb in |
| Power Steering Pump Bolt | 22 N.m | 16 lb ft |
| Steering Gear Bolt (1) | ||
|
110 N.m | 81 lb ft |
|
150 degrees | |
| Steering Gear Pipe Fitting | 19 N.m | 14 lb ft |
| Steering Gear Pipe Retainer Fastener | 12 N.m | 106 lb in |
| Steering Linkage Inner Tie Rod | 100 N.m | 74 lb ft |
| Steering Linkage Outer Tie Rod Nut (1) | ||
|
35 N.m | 26 lb ft |
|
30 degrees | |
| 1. Use a NEW fastener. | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.