2012 Buick Regal BaseFACTORY OEM SERVICE PROCEDURE

Disc Brake Component Specifications

WARNING: This page is about a different car, the 2011 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Application Specification
Metric English
Front Brakes
  • Brake Rotor Diameter (J60)
296.0 mm 11.65 in
  • Brake Rotor Diameter (J61)
321.0 mm 12.63 in
  • Brake Rotor Discard Thickness* (J60, J61)
27.0 mm 1.07 in
  • Brake Rotor Maximum Allowable Assembled Lateral Runout
0.05 mm 0.002 in
  • Brake Rotor Maximum Allowable Scoring
1.50 mm 0.059 in
  • Brake Rotor Maximum Allowable Thickness Variation
0.006 mm 0.00024 in
  • Brake Rotor Thickness New (J60, J61)
30.0 mm 1.18 in
Rear Brakes
  • Brake Rotor Diameter (J60)
292.0 mm 11.50 in
  • Brake Rotor Diameter (J61)
315.0 mm 12.40 in
  • Brake Rotor Discard Thickness* (J60)
10.00 mm 0.395 in
  • Brake Rotor Discard Thickness* (J61)
21.00 mm 0.827 in
  • Brake Rotor Maximum Allowable Assembled Lateral Runout
0.05 mm 0.002 in
  • Brake Rotor Maximum Allowable Scoring
1.50 mm 0.059 in
  • Brake Rotor Maximum Allowable Thickness Variation
0.006 mm 0.00024 in
  • Brake Rotor Thickness - New (J60)
12 mm 0.472 in
  • Brake Rotor Thickness - New (J61)
23.0 mm 0.905 in
*All brake rotors have a discard dimension cast into them. Replace any rotor that does not meet this specification. After refinishing the rotor, replace any rotor that does not meet the discard thickness specification.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.