2012 Buick Regal BaseFACTORY OEM SERVICE PROCEDURE

Communication Interface Module Battery Replacement

WARNING: This page is about a different car, the 2011 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Communication Interface Module Battery
GM2335601Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure:Β 
Remove the communication interface module bracket. Refer to Communication Interface Module Bracket ReplacementΒ .
1 Communication Interface Module Battery

Procedure

  1. Unsnap the communication interface module battery from the bracket.
  2. Disconnect the electrical connectors.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.