2012 Buick Regal BaseFACTORY OEM SERVICE PROCEDURE

Fuel Tank Pressure Sensor Replacement (NU6)

Fig 1: Fuel Tank Pressure Sensor (NT7)
GM2205647Courtesy of GENERAL MOTORS COMPANY
Fuel Tank Pressure Sensor Replacement (NU6)

Callout Component Name
Preliminary Procedure 
Remove the fuel tank. Refer to Fuel Tank Replacement .
1 Fuel Tank Pressure Sensor

Procedure

  1. Disconnect the electrical connector.
  2. Release the retaining tab.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.