Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Buick Regal BaseFACTORY OEM SERVICE PROCEDURE
Removal Procedure
- Relieve the low and high side fuel system pressure. Refer to Fuel Pressure Relief .
- Disconnect the engine wiring harness electrical connector from the high pressure fuel pump.
- Remove the low pressure feed pipe. Refer to Fuel Feed Pipe Replacement .
- Remove the high pressure pipe. Refer to Fuel Feed Intermediate Pipe Replacement . Discard this pipe.
- Remove and discard the high pressure fuel pump bolts (1).
- Remove the high pressure fuel pump (2).
- Remove and discard the high pressure fuel pump O-ring (3).
- Remove and discard the high pressure fuel pump gasket (4).
- Remove the high pressure fuel pump roller lifter (5).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.