2012 Buick Regal BaseFACTORY OEM SERVICE PROCEDURE

Fuel Feed Pipe Replacement

Fig 1: Fuel Feed Pipe (LAF)
GM2210916Courtesy of GENERAL MOTORS COMPANY
Fuel Feed Pipe Replacement

Callout Component Name

Preliminary Procedures

  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  2. Disconnect the fuel lines. Refer to Metal Collar Quick Connect Fitting Service .
1 Fuel Feed Pipe Fastener
CAUTION:

Refer to Fastener Caution .


Tighten 
10 N.m (89 lb in)
2 Fuel Feed Pipe
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.