2012 Buick Regal BaseFACTORY OEM SERVICE PROCEDURE

Keyless Entry Control Module Replacement

Fig 1: Keyless Entry Control Module
GM2193978Courtesy of GENERAL MOTORS COMPANY
Keyless Entry Control Module Replacement

Callout Component Name

Preliminary Procedures

  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the instrument panel compartment. Refer to Instrument Panel Compartment Replacement .
1 Wiring Harness Bracket
Procedure 
Release the wiring harness bracket.
2 Keyless Entry Control Module

Procedure

  1. Disconnect the wiring harness connectors.
  2. Clip out the fixing points from the keyless entry control module.
  3. Remove the keyless entry control module.
  4. After repairs, for programming and set up information. Refer to Control Module References .
Chapter Navigation
Return to Chapter: Repair Instructions
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.