2011 Buick LaCrosse CXSFACTORY OEM SERVICE PROCEDURE

Rearview Camera Image Display Module Replacement

WARNING: This page is about a different car, the 2010 Buick LaCrosse. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rearview Camera Image Display Module
GM2207687Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure:Β 
Remove the rear compartment lid applique. Refer to Rear Compartment Lid Applique Replacement .
1 Rearview Camera

Procedure

  1. Disconnect the electrical connector
  2. Depress the clip fingers and push outward to remove the rearview camera.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.