Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSBUICK2011ENCLAVE CXL, FWDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSKEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONSREPAIR INSTRUCTIONSREMOTE CONTROL DOOR LOCK RECEIVER REPLACEMENT

2011 Buick Enclave CXL, FWD

Remote Control Door Lock Receiver Replacement

2011 Buick Enclave CXL, FWDSECTION Remote Control Door Lock Receiver Replacement

Fig 1: Identifying Remote Control Door Lock Receiver

Courtesy of GENERAL MOTORS CORP.

Callout

Component Name

Preliminary Procedure
Lower the rear of the headliner trim panel. Refer to Headlining Trim Panel Replacement .

Remote Control Door Lock Receiver

Procedures

Disconnect the electrical connector.
The module slides and snaps into the body structure.
If a replacement module is installed, program the module. Refer to Control Module References .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.