2008 Buick Enclave CX, AWDFACTORY OEM SERVICE PROCEDURE

Object Alarm Module Replacement

Fig 1: View Of Object Alarm Module
GM1847695Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove the left rear quarter lower trim panel. Refer to Rear Quarter Lower Trim Panel Replacement (Acadia/OUTLOOK with E61) or Rear Quarter Lower Trim Panel Replacement (Acadia/OUTLOOK without E61) or Rear Quarter Lower Trim Panel Replacement (Enclave with E61) or Rear Quarter Lower Trim Panel Replacement (Enclave without E61) .
  2. Remove the liftgate actuator (if equipped). Refer to Liftgate Actuator Replacement .
1 Communication Interface Module Bracket

Procedure

  1. Disconnect the body harness from the bracket as required.
  2. Loosen the bracket fasteners to remove the bracket from the slotted holes.
  3. Disconnect the electrical connectors.
2 Rear Object Alarm Module
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.