SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2007RENDEZVOUS V6-3.5LREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY MODULESERVICE AND REPAIR
2007 Buick Rendezvous V6-3.5L

Keyless Entry Module: Service and Repair

2007 Buick Rendezvous V6-3.5LSECTION Service and Repair


Remote Control Door Lock Receiver Replacement

Removal Procedure

1. Remove the upper trim pad.




2. Disconnect the remote control door lock receiver electrical connector (1).

Important: Disengage the remote control door lock receiver retainers and lift upward.

3. Remove the remote control door lock receiver (2) from the defroster air duct.

Installation Procedure






Important: Position the remote control door lock receiver to the defroster air duct.

1. Install the remote control door lock receiver (2).
2. Engage the remote control door lock receiver retainers.
3. Connect the remote control door lock receiver electrical connector (1).
4. Install the upper trim pad.
5. If a new remote control door lock receiver is being installed, program the transmitter. Refer to Programming and Relearning Programming and Relearning
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.