2007 Buick Allure CXFACTORY OEM SERVICE PROCEDURE

Steering Wheel Control Switch Assembly Replacement

Fig 1: Replacing Steering Wheel Control Switch Assembly
GM1658657Courtesy of GENERAL MOTORS CORP.
Steering Wheel Control Switch Assembly Replacement

Callout Component Name
NOTE: Refer to Fastener Notice .
Preliminary Procedure:Β Remove the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
1 Upper Steering Wheel Control Switch (Qty: 2)
Tip:Β 
  1. Use a flat-bladed tool to remove the switch from the steering wheel.
  2. Disconnect the electrical connector from the switch.
2 Lower Steering Wheel Control Switch Screw (Qty: 2),

Tighten:Β  2 N.m (18 lb in)

3 Lower Steering Wheel Control Switch (Qty: 2)
Tip:Β  Disconnect the electrical from the switch.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.