2006 Buick Lucerne CXFACTORY OEM SERVICE PROCEDURE

Removal Procedure

WARNING: This page is about a different car, the 2007 Buick LaCrosse and 2007 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: A new sunroof module assembly will not have the sunroof window or sunshade as components of the new service part.
  1. The old sunroof window and sunshade will need to be installed to the new sunroof module assembly.
  2. Remove the sunroof window. Refer to Sunroof Window ReplacementΒ .
  3. Fig 1: Removing/Installing Sunroof Module Electrical Connector
    GM647217Courtesy of GENERAL MOTORS CORP.
  4. Remove the sunshade panel. Refer to Sunroof Sunshade ReplacementΒ .
  5. Remove the headliner. Refer to Headlining Trim Panel Replacement .
  6. Disconnect the electrical connector from the sunroof module.
  7. Fig 2: Sunroof Module Drain Hoses
    GM791513Courtesy of GENERAL MOTORS CORP.
  8. Disconnect the front and rear drain hoses from the sunroof module.
  9. Fig 3: Sunroof Module & Components
    GM317129Courtesy of GENERAL MOTORS CORP.
  10. Have an assistant support the sunroof module.
  11. Remove the bolts from the sunroof module.
  12. Remove the sunroof module from the vehicle with an assistant.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.