2006 Buick Allure CXFACTORY OEM SERVICE PROCEDURE

Front Of Engine Component View

Fig 1: View Of Front Of Engine
GM1552089Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Ignition Coil Module
2 Manifold Absolute Pressure (MAP) Sensor
3 Fuel Injector 1
4 Fuel Injector 3
5 Fuel Injector 5
6 Exhaust Gas Recirculation (EGR) Valve
7 Throttle Actuator Control (TAC) Module
8 Engine Coolant Temperature (ECT) Sensor
9 Starter Solenoid
10 Starter
11 Engine Oil Level Switch
12 Knock Sensor (KS) 1
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.