2005 Buick LeSabre V6-3.8L VIN KFACTORY OEM SERVICE PROCEDURE

Ignition Control Module: Service and Repair



IGNITION CONTROL MODULE REPLACEMENT

REMOVAL PROCEDURE
1. Turn the ignition OFF.
2. Disconnect the 14-way connector from the ignition control module (ICM).
3. Disconnect the spark plug wires from the coil assemblies. Before removing the wires, note the position of the wires.

Factory service manual diagram



4. Remove the screws (1) that secure the coil assemblies (2) to the ICM (3).
5. Remove the coils (2) and the ICM (3) from the bracket.

INSTALLATION PROCEDURE

Factory service manual diagram



1. Attach the coils (2) and the ignition control module (3) to the bracket.
2. Install the screws (1) that retain the ignition coils (2) and the ICM (3) to the bracket.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screws to 4.5 N.m (40 lb in).

3. Connect the spark plug wires.
4. Connect the 14-way connector to the module.

Tighten the screw to 2.1 N.m (19 lb in).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.