Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Buick LeSabre V6-3.8L VIN KFACTORY OEM SERVICE PROCEDURE
Cruise Control Module: Service and Repair
CRUISE CONTROL MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the cruise control cable.
2. Disconnect the electrical connector (2).
3. Remove the cruise control module bracket retaining fasteners (1, 3).
4. Remove the cruise control module and bracket assembly (2) from the vehicle.
5. Remove the module to bracket fasteners.
6. Remove the cruise control module from the bracket.
INSTALLATION PROCEDURE
1. Install the cruise control module (2) to the bracket.
2. Install the module to bracket fasteners.
Tighten the fasteners to 7.5 N.m (66 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the cruise control module and bracket assembly to the vehicle.
4. Install the module retaining fasteners (1, 3).
Tighten the fasteners to 9 N.m (80 lb in).
5. Connect the electrical connector (2).
6. Connect the cruise control cable.
IMPORTANT: The cruise control cable does not require mechanical adjusting after the replacement. The cruise control module internally adjusts the cable. Refer to Cruise Control Description and Operation for the complete operational details.
7. Inspect the component operation.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
