Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Buick Century CustomFACTORY OEM SERVICE PROCEDURE
Removal Procedure
The heated oxygen sensor may be difficult to remove when engine temperature is below 48° C (120° F). Excessive force may damage threads in exhaust manifold or exhaust pipe.
- Disconnect the heated oxygen sensor (HO2S) electrical connector.
- Use the J 39194-B to remove the heated oxygen sensor (HO2S). See Special Tools .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.